Which of the following forced convection heat transfer equation accounts for the liquid viscosity effect for viscous liquids ?
Correct answer: B. Sieder-Tate equation
- A. Dittus-Boelter equation
- B. Sieder-Tate equation
- C. Nusselt equation
- D. None of these
Explanation
The Sieder-Tate correlation includes a viscosity correction, commonly written as a ratio of bulk to wall viscosity, so it is suitable for viscous liquids. The Dittus-Boelter equation does not account adequately for this viscosity effect.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Heat Transfer Operations
645 free Heat Transfer Operations MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Heat Transfer Operations questions
Three solid objects of the same material and of equal mass-a sphere, a cylinder (length = diameter) and a cube are at 500°C initially. These are dropped in a quenching bath containing a large volume of cooling oil each attaining the bath temperature eventually. The time required for 90% change in temperature is the smallest for_________________?
The Fourier number (defined as a.t/L2) is used in the analysis of problem involving heat transfer by_______________?
The outlet temperature of cooling water in a heat exchanger is generally not allowed to exceed above 50°C in industrial practice mainly to avoid_________________?
For condensation of pure vapors, if the heat transfer co-efficients in filmwise and drop-wise condensation are respectively hf and hd, then__________________?
Heat transfer in the laminar sub-layer in case of a liquid flowing through a pipe, is mostly by__________________?
_____________ heat exchanger is the most suitable, when the temperature of shell side fluid is much higher than that of tube side?