Which instructions are used to transfer data from one memory location to another?
Correct answer: A. Data transfer instructions.
- A. Data transfer instructions.
- B. Control instructions
- C. Arithmetic and logic instructions
- D. Instruction set
Explanation
Data transfer instructions are a fundamental type of instruction in computer programming. They are used to move data between different parts of the computer's memory, including:Registers: Small, temporary storage locations within the CPUMain memory (RAM): The primary memory where programs and data are stored while the computer is runningSecondary storage (hard drives, SSDs): Slower, non-volatile storage used to hold data long-term
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
About Hardware and Software
Hardware includes the physical components of a computer, such as the CPU, motherboard, registers, memory, storage devices and peripheral equipment. Software covers system software, application software, utilities, drivers and firmware, with attention to how the operating system manages hardware and how software differs from the physical equipment it controls.
Practise Hardware and Software
290 free Hardware and Software MCQs from Computer Science and IT, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Computer Science and IT questions like this
Computer Science and IT is on 85 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
More Hardware and Software questions
After decoding the instruction, the processor performs which type of action by using the activated circuits?
After decoding the instruction, the processor performs which type of action by using the activated circuits?
Which of the following techniques is used to store data in a stack?
Which of the following are functions of an operating system?
Which one of the following errors will be handled by the operating system?
How many bits are used in three address instruction formats?