The temperature at the eutectic point of the system is the _____________ temperature that can be attained in the system?
Correct answer: A. Lowest
- A. Lowest
- B. Highest
- C. Average
- D. None of these
Explanation
The eutectic temperature is the lowest temperature at which the liquid phase can exist in the system; below it, the components are entirely solid. This makes the eutectic point the minimum equilibrium temperature on the phase diagram.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Chemical Engineering Thermodynamics
598 free Chemical Engineering Thermodynamics MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Chemical Engineering Thermodynamics questions
The value of Cp & Cv respectively for monatomic gases in Kcal/kg Mole.°K are________________?
Which of the following represents the Virial equation of state ?
_______________ increases with increase in pressure?
For an ideal gas, the internal energy depends upon its ____________ only?
For water at 300°C, it has a vapour pressure 8592.7 kPa and fugacity 6738.9 kPa Under these conditions, one mole of water in liquid phase has a volume of 25.28 cm3 and that in vapour phase in 391.1 cm3.Fugacity of water (in kPa) at 9000 kPa will be__________________?
If the vapour pressure at two temperatures of a solid phase in equilibrium with its liquid phase are known, then the latent heat of fusion can be calculated by the _________________?