The maximum output voltage of a certain low-pass filter is 15 V. The output voltage at the critical frequency is_____________?
Correct answer: A. 10.60 V
- A. 10.60 V
- B. 0 V
- C. 21.21 V
- D. 15 V
Explanation
At the critical frequency of a first-order low-pass filter, the output falls to 0.707 of its maximum value. Thus, 0.707 × 15 V = 10.6 V.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
Practise Electronics and Devices
758 free Electronics and Devices MCQs from Electrical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Electrical Engineering questions like this
Electrical Engineering is on 2 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
More Electronics and Devices questions
In a series resonant band-pass filter, a lower value of Q results in______________?
An RC high-pass filter consists of an 820 Ω resistor. What is the value of C so that Xc is ten times less than Rat an input frequency of 12 kHz?
In a certain low-pass filter, fc = 3.5 kHz. Its pass-band is_______________?
A sinusoidal voltage with a peak-to-peak value of 18 V is applied to an RC low-pass filter. If the reactance at the input frequency is zero, the output voltage is____________?
Vout = 500 mV, and Vin = 1.3 V. The ratio Vout/ Vin expressed in dB is__________?
A parallel resonant band-pass filter consists of a 6.8 Ω resistor in series with a parallel network made up of an 8 µH coil and a 120 pF capacitor. The output is taken across the capacitor/coil. Assume RW = 0 Ω. What is the center frequency of the filter?