Stresses encountered in the metal forming processes are less than the _____________ of the material?
Correct answer: A. Fracture strength
- A. Fracture strength
- B. Yield strength
- C. Elastic limit
- D. Limit of proportionality
Explanation
Metal-forming stresses must be high enough to cause plastic deformation, but they remain below the material’s fracture strength. Therefore, the limiting condition mentioned here is fracture strength.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Plant Design and Economics
803 free Plant Design and Economics MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Plant Design and Economics questions
Damage to metal surface by mechanical action is called____________________?
Breakeven point represents the condition, when the company runs under no profit no loss condition. In break even analysis, total cost comprises of fixed cost________________?
________________ property of steel increases by addition of large amount of silicon in it?
Materials having ________________ lattice structure are usually the most ductile ?
A dummy activity is used in PERT network to describe the_____________________?
Large diameter reinforced cement concrete (RCC) pipes are generally joined by ____________________ joint ?