Regulator sampling PWM is usually used in___________?
Correct answer: D. Only A. and B.
- A. High power inverters
- B. Rectifiers
- C. Low power inverters
- D. Only A. and B.
Explanation
Regular-sampling PWM is commonly used in high-power inverters and PWM rectifiers because its fixed sampling process is convenient for digital control at relatively low switching frequencies. Hence both A and B apply.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
Practise Power Electronics
253 free Power Electronics MCQs from Electrical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Electrical Engineering questions like this
Electrical Engineering is on 2 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
More Power Electronics questions
A combination of synchronized leading edge and trailing edge modulation has also been used to control a____________?
If energy is taken from the AC side of the inverter and sends it back into the DC side, then it is known as___________?
The ac output voltage waveform of VSI and AC output current waveform of CSI respectively is composed of___________?
In a 3 phase VSI SPWM to use a single carrier signal and preserve the features of PWM technique, the normalized carrier frequency should be____________?
In square wave operation mode of 3 phase VSI, the VSI
For commutation in three phase PAC, normally balanced three phase voltages VR, VY and VB are connected to the three legs of the converter via______________?