In square wave operation mode of 3 phase VSI, the VSI
Correct answer: C. Cannot control the load voltage except by means of dc link voltage
- A. Can control the load voltage
- B. Cannot control the load voltage
- C. Cannot control the load voltage except by means of dc link voltage
- D. Cannot control the load voltage except by means of dc link current
Explanation
In square-wave operation the switches have fixed conduction intervals, so the VSI cannot vary its output magnitude through modulation. The load voltage can only be adjusted by changing the DC-link voltage.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
Practise Power Electronics
253 free Power Electronics MCQs from Electrical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Electrical Engineering questions like this
Electrical Engineering is on 2 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
More Power Electronics questions
In a 3 phase VSI SPWM to use a single carrier signal and preserve the features of PWM technique, the normalized carrier frequency should be____________?
Regulator sampling PWM is usually used in___________?
A combination of synchronized leading edge and trailing edge modulation has also been used to control a____________?
For commutation in three phase PAC, normally balanced three phase voltages VR, VY and VB are connected to the three legs of the converter via______________?
If all the SCR's of 3 phase PAC is replaced by diodes, they would be triggered_____________?
The output current in PWM DC - DC converters is equal to___________?