In which rectifier ripple factor is less?
Correct answer: A. Full wave
- A. Full wave
- B. Half wave
- C. Both a) and b)
- D. None of them
Explanation
A bridge rectifier is a type of full-wave rectifier. A full-wave rectifier is a circuit that converts the entire input waveform into a DC output waveform. A bridge rectifier is one of the most commonly used full-wave rectifier circuits. It uses four diodes arranged in a bridge configuration to rectify the AC input voltage. The four diodes allow the circuit to use both halves of the AC input waveform, resulting in a higher output voltage and a lower ripple factor than a half-wave rectifier. So, a bridge rectifier is a type of full-wave rectifier that is more efficient and has a lower ripple factor than a half-wave rectifier.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
About Electronics
A p-n junction forms when p-type and n-type semiconductor regions meet, creating a depletion layer, barrier potential and rectifying action. The work covers forward and reverse bias, junction current, diode characteristics, and how a diode converts alternating current into pulsating direct current through half-wave and full-wave rectification.
Practise Electronics
660 free Electronics MCQs from Physics, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Physics questions like this
Physics is on 16 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
More Electronics questions
The peak voltage in the output of the full wave rectifier is 10V so the dc component of the output voltage is:
The Centre tape rectifier circuit consists of _ diodes.
A full wave rectifier is operating from 50 Hz mains. The fundamental frequency of ripple will be:
A half wave rectifier is operating from 50 Hz mains. The fundamental frequency of ripple will be:
Which of the following rectifiers uses a Wheatstone bridge to rectify the signal:
In which the rectifier ripple factor is less: