_____________ heat exchanger is used for chilling oil to be dewaxed?
Correct answer: B. Double pipe
- A. U-tube
- B. Double pipe
- C. Fixed tube
- D. Floating head
Explanation
A double-pipe heat exchanger is commonly used for chilling oil during dewaxing because it provides a simple arrangement suitable for viscous fluids and relatively small processing rates. Fixed-tube and floating-head exchangers are more typical for larger duties.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Heat Transfer Operations
645 free Heat Transfer Operations MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Heat Transfer Operations questions
It is not preferable to use superheated steam in evaporators, because of its very_________________?
A single pass air heater is connected to a two pass unit. For the air flow rate and other conditions remaining the same, the film heat transfer co-efficient for air will vary in the ratio of__________________?
When warm and cold liquids are mixed, the heat transfer is mainly by_______________?
If heat transfer rate varies with the time, it is termed as__________________?
The inner wall of a furnace is at a temperature of 700°C. The composite wall is made of two substances, 10 and 20 cm thick with thermal conductivities of 0.05 and 0.1 W.m-1.°C- 1 respectively. The ambient air is at 30°C and the heat transfer co-efficient between the outer surface of wall and air is 20 W.m-2.°C-1. The rate of heat loss from the outer surface in W.m-2is__________________?
The absorptivity of a body is equal to its emissivity _________________?