Frame thickness in the plate and frame filter press is normally in the range of ______________ inches?
Correct answer: B. 0.25 to 8
- A. 0.25 to 4
- B. 0.25 to 8
- C. 1 to 5
- D. 1 to 12
Explanation
Plate and frame filter presses use frames of different depths to provide the required cake capacity, commonly ranging from about 0.25 to 8 inches. The other ranges either omit the standard lower limit or extend beyond the usual range.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
Practise Fluid Flow Operations
909 free Fluid Flow Operations MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Fluid Flow Operations questions
A/an _______________ is used for changing the direction of a pipeline?
Filtration rate is affected by the________________?
The equivalent diameter for fluid flow through a channel of constant non-circular cross section of area 'A' is given by (where, P = perimeter of the channel in contact with the fluid) ?
The dust collection efficiency of a cyclone separator_________________?
(Le/D) for a Tee (used as elbow, entering run) would be around _______________________?
For turbulent flow (NRe > 2100) of low viscosity fluid (μ > 20cp) in steel pipes, the optimum inside pipe diameter is given by(where, Q = fluid flow rate, ft3/sec, ρ = fluid density, lb/ft3 μ = fluid viscosity, centipoise Di = optimum inside pipe diameter, inches) ?