Capacity of one lead accumulator cell is
Correct answer: B. 2 volts
- A. 1.5 volts
- B. 2 volts
- C. 3 volts
- D. 1 volt
Explanation
The capacity of a lead accumulator cell can be expressed in both Ampere-hours (Ah) or Watt-hours (Wh) and volts,depending on the context. However, in this specific case, assuming the question refers to the nominal voltage the cell can maintain for a certain duration, the most likely correct answer is:2 voltsLead accumulator cells have a relatively stable voltage output during discharge. They are often rated based on the voltage they can maintain for a specific time before needing recharge.2 volts is a typical minimum voltage considered acceptable for most applications involving lead accumulators.Maintaining a voltage above 2 volts ensures sufficient functionality.While other options like 1.5 volts or 3 volts could be possible ratings for specific lead accumulator cells, 2 volts is a more common reference point due to its reliability and performance in various applications.
Last updated
About Electrochemistry
Electrochemistry describes electron transfer through oxidation and reduction, identifies oxidizing and reducing agents, and applies oxidation numbers to balance redox equations. It also covers electrode potential and the standard hydrogen electrode, which provides the reference for comparing the reduction tendencies of other electrodes.
Practise Electrochemistry
696 free Electrochemistry MCQs from Chemistry, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemistry questions like this
Chemistry is on 12 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
Related questions
10-2 mole of Fe3O4 is treated with excess KI solution in presence of dilute H2SO4, the products are Fe2+ and I2(g). What volume of 0.1 (M) Na2S2O3 will be needed to reduce the liberated I2(g)?
+3 and +5 oxidation states are often shown by:
3 faraday of electricity is passed through molten Al2O3 , aqueous solution of CuSO4 and molten NaCl taken in three different electrolytic cells. The amount of Al, Cu and Na deposited at the cathodes will be in the ratio of:
5.3 gm of M2CO3 is dissolved in 150 ml of 1N HCl. The unused acid required 100 ml of 0.5N NaOH. Hence equivalent weight of M is:
8H++ MnO4- → Mn2+ + 4H2O , which one is correct about given equation?