TestUstad

A circuit that adds positive or negative D.C. voltage to an input sine wave is called:

Correct answer: A. Clamper

  • A. Clamper
  • B. Clipper
  • C. Diode clamp
  • D. Limiter

Explanation

A clamper is an electronic circuit that changes the DC level of a signal to the desired level without changing the shape of the applied signal. In other words, the clamper circuit moves the whole signal up or down to set either the positive peak or negative peak of the signal at the desired level. So, only option A is correct.

Written and checked by , contributorLast updated
Report an error

The more specific you are, the faster it gets fixed. A source beats an opinion.

Prefer email? [email protected]

About Alternating Current

Alternating current varies periodically, so phase relationships become essential when current passes through a resistor, capacitor or inductor. The chapter distinguishes resistance from capacitive and inductive reactance, explains phase lead and lag, and connects changing electric and magnetic fields with the production and properties of electromagnetic waves.

Practise Alternating Current

592 free Alternating Current MCQs from Physics, each with the correct answer and an explanation. Unlimited attempts, no account needed.

Start a free Alternating Current testAll Alternating Current MCQs

Discussion

Stuck on an option, or know a faster way to get there? Ask or explain it here.

No comments yet. Be the first to explain this one.

Exams that ask Physics questions like this

Physics is on 16 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.

Lecturer Physics Test Physics80 MCQsSubject Specialist Physics Test Physics80 MCQsNET Physics60 MCQsNUMS Physics40 MCQsDUHS Physics36 MCQsETEA MDCAT Physics36 MCQsKMU Physics36 MCQsMDCAT Physics36 MCQsECAT Physics30 MCQsETEA Engineering Admission Test Physics30 MCQsGIKI Physics30 MCQsNED Physics30 MCQsPIEAS Physics30 MCQsPMD Physics25 MCQsBSN Entry Test Physics20 MCQsPAF Airman Physics15 MCQs

More Alternating Current questions

In case of half wave rectification the resistance of diode during negative half of A.C is:

In a practical transformer mutual induction between primary and secondary coils takes place. In such transformer what can be deduced about the power.

What is the instantaneous power dissipated through a resistor of resistance 10 ohm if it is connected to an AC source of frequency 15 Hz at 1/180 sec if peak value is 20 V?

The output voltage of a rectifier is:

If an AC voltage of rms value of 10 volts is applied as input of a half-wave rectifier, then the voltage value of the DC output will be:

In a bridge type full-wave rectifier, if Vm is the peak voltage across the secondary coil of the transformer, the maximum voltage coming across each reverse biased diode is: