Which type of heat exchanger is preferred for heavy heat loads ?
Correct answer: C. Series and parallel set of shell and tube
- A. Double pipe
- B. Plate fine
- C. Series and parallel set of shell and tube
- D. None of these
Explanation
Shell-and-tube exchangers can be arranged in series and parallel to provide a very large heat-transfer area and handle high heat duties. Double-pipe units are more suitable for smaller duties.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Heat Transfer Operations
645 free Heat Transfer Operations MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Heat Transfer Operations questions
The unit of heat transfer co-efficient in SI unit is____________________?
If the baffle spacing in a shell and tube heat exchanger increases, then the Reynolds number of the shell side fluid_________________?
Fouling factor_____________________?
With increase in porosity, the thermal conductivity of a solid substance__________________?
The number of kg vaporised per kg of steam fed to the evaporator is defined as____________?
Convective heat transfer co-efficient in case of fluid flowing in tubes is not affected by the tube length/diameter ratio, if the flow is in the _____________ zone?