Which of the following parameters of the fluid is not very important, while deciding its route in a shell and tube heat exchanger ?
Correct answer: A. Density
- A. Density
- B. Pressure
- C. Viscosity
- D. Corrosiveness & fouling characteristics
Explanation
Fluid routing depends strongly on corrosiveness, fouling tendency, pressure and viscosity because these affect material selection, allowable pressure drop and pumping. Density has comparatively little influence on deciding which fluid goes through the shell or tubes.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
Practise Heat Transfer Operations
645 free Heat Transfer Operations MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Heat Transfer Operations questions
Dropwise condensation is promoted on a/an ______________ surface?
In a forward feed multiple effect evaporator unit__________________?
Steam economy in case of a triple effect evaporator will be _________________?
It is desired to concentrate a 20% salt solution (20 kg of salt in 100 kg of solution) to a 30% salt solution in an evaporator. Consider a feed of 300 kg/min at 30°C. The boiling point of the solution is 110°C, the latent heat of vaporisation is 2100 kJ/kg and the specific heat of the solution is 4 kJ/kg.K. The rate at which the heat has to be supplied in (kJ/min) to the evaporator is____________________?
Fqra cold viscous feed, backward feed gives _____________ than forward feed?
The Graetz number is concerned with the___________________