Which of the following is not a type of rectifier?
Correct answer: A. Phase wave rectifier
- A. Phase wave rectifier
- B. Full wave
- C. halfwave
- D. none of them
Explanation
A phase wave rectifier is not a recognized type of rectifier. The commonly known types of rectifiers are full wave rectifier and half wave rectifier. A rectifier is an electronic device used to convert alternating current (AC) into direct current (DC). In a full wave rectifier, both halves of the AC waveform are utilized, while in a half wave rectifier, only one half of the AC waveform is used. The option "none of them" implies that none of the given options are types of rectifiers, which is incorrect since full wave and half wave rectifiers are well-known types.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
About Electronics
A p-n junction forms when p-type and n-type semiconductor regions meet, creating a depletion layer, barrier potential and rectifying action. The work covers forward and reverse bias, junction current, diode characteristics, and how a diode converts alternating current into pulsating direct current through half-wave and full-wave rectification.
Practise Electronics
660 free Electronics MCQs from Physics, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Physics questions like this
Physics is on 16 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
More Electronics questions
Gamma rays are attracted towards
The number of diodes in centre-tapped full-wave rectifier is:
The principle behind the working of cathode ray oscilloscope is which of the following?
A full wave rectifier uses a load resistor of 1500 ohms. Assume the diodes have Rf=10 Ohms and Rr= infinite. The voltage applied to the diodes is 30V with a frequency of 50Hz. Calculate the AC power input.
If the peak voltage in the output of full-wave rectifier is 10V, then the DC component of output voltage is:
In a centre tap full-wave rectifier, if Vm is the peak voltage across the secondary coil of a transformer, the maximum voltage across the reverse bias is: