Which of the following is a type of rectifier?
Correct answer: D. All of the above options are correct
- A. Half wave
- B. Full wave
- C. Bridge
- D. All of the above options are correct
Explanation
Option A: A half-wave rectifier converts an AC signal to DC by passing either the negative or positive half-cycle of the waveform and blocking the other. Half-wave rectifiers can be easily constructed using only one diode, but are less efficient than full-wave rectifiers.Option B: A full wave rectifier is defined as a rectifier that converts the complete cycle of alternating current into pulsating DC. Unlike halfwave rectifiers that utilize only the halfwave of the input AC cycle, full wave rectifiers utilize the full cycle.Option C: bridge rectifiers is a type of full-wave rectifier that uses four or more diodes in a bridge circuit configuration to efficiently convert alternating (AC) current to a direct (DC) current.Option D: All are right options.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
About Electronics
A p-n junction forms when p-type and n-type semiconductor regions meet, creating a depletion layer, barrier potential and rectifying action. The work covers forward and reverse bias, junction current, diode characteristics, and how a diode converts alternating current into pulsating direct current through half-wave and full-wave rectification.
Practise Electronics
660 free Electronics MCQs from Physics, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Physics questions like this
Physics is on 16 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
More Electronics questions
A full wave rectifier uses a load resistor of 1500 Ω. Assume the diodes have Rf= 10 Ω, Rr= ∞. The voltage applied to the diode is 30V with a frequency of 50Hz. Calculate the AC power input.
The process of converting alternating current to direct current is called:
Consider a peak rectifier fed by a 60-Hz sinusoid having a peak value Vp = 100 V. Let the load resistance R = 10 kΩ. Calculate the fraction of the cycle during which the diode is conducting:
If a half-wave rectifier is used to convert 50Hz AC into DC, then the number of pulses present in the rectifier voltage is:
A transformer is used in rectification to _ the supply voltage.
A full wave rectifier uses a load resistor of 15000. Assume the diodes have Rf=l0 Ohms and Rr= infinite. The voltage applied to the diodes is 30V with a frequency of 50Hz. Calculate the AC power input.