When the solvent dissolves very little of solute, then__________________________?
Correct answer: C. Large quantity of solvent is required to extract the solute
- A. Solvent of low latent heat of vaporisation should be used
- B. Solvent of low freezing point should be used
- C. Large quantity of solvent is required to extract the solute
- D. Very small quantity of solvent is required
Explanation
If the solvent has low solubility for the solute, each unit of solvent extracts only a small amount. Consequently, a large quantity of solvent is needed to achieve the desired recovery.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Mass Transfer Operations
669 free Mass Transfer Operations MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Mass Transfer Operations questions
Bollman extractor___________________?
In case of absorption, both the operating and equilibrium lines will be straight for______________?
The most economical range of absorption factor is____________________?
Tea percolation employs___________________________?
The equipment used in the extraction of highly corrosive radioactive liquids is_______________________?
With increase in temperature, the solubility of gases in liquids, at fixed pressure____________________?