Vernier calipers cannot be used to measure the______________________?
Correct answer: D. Clearance between two mating surfaces
- A. I.D. & O.D. of the shaft
- B. Thickness of parts
- C. Depth of holes
- D. Clearance between two mating surfaces
Explanation
Vernier calipers measure outside and inside dimensions, thickness, and hole depth. Clearance between mating surfaces is normally measured with a feeler gauge, so it is the unsuitable application here.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Chemical Process Principles
2,710 free Chemical Process Principles MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Chemical Process Principles questions
Powder metallurgy process does not make metal powder by_________________________?
Wrought iron is not____________________?
Cast iron contains ____________________ percent carbon?
The softness or hardness of a grinding wheel depends upon the type & amount of bonding material used. For general purpose cutter grinding _______________ grinding wheel is normally used ?
Sudden fall of atmospheric pressure by a large amount is an indication of the_____________________?
Which of the following is not a charge material for cupola ?