There is a change in ______________ during the phase transition?
Correct answer: A. Volume
- A. Volume
- B. Pressure
- C. Temperature
- D. All a, b & c
Explanation
During a usual first-order phase transition, the specific volume changes because the two phases have different densities. At equilibrium, pressure and temperature may remain fixed during the transition, so “all” is not correct.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Chemical Engineering Thermodynamics
598 free Chemical Engineering Thermodynamics MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Chemical Engineering Thermodynamics questions
In Joule-Thomson porous plug experiment, the__________________?
A cyclic engine exchanges heat with two reservoirs maintained at 100 and 300°C respectively. The maximum work (in J) that can be obtained from 1000 J of heat extracted from the hot reservoir is_________________?
Trouton's ratio of ______________ liquids is calculated using Kistyakowsky equation?
Cv is given by__________________?
A thermodynamic system is taken from state A to B along ACB and is brought back to A along BDA as shown below in the P-V diagram. The net work done during the complete cycle is given by the area covered by_________________?
Salt content in sea water is about ______________ percent?