The minimum number of diodes required for full wave rectification are:
Correct answer: B. 2
- A. 1
- B. 2
- C. 3
- D. 4
Explanation
For full wave rectification, the minimum number of diodes required is two (This is for a center-tapped full wave rectifier configuration).However, if you're referring to a full wave bridge rectifier, then four diodes are needed.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
About Rectification
Rectification converts alternating current into unidirectional current using semiconductor diodes. The content includes half wave and full wave rectifiers, bridge circuits, output waveforms, ripple and smoothing with capacitors, with the difference between rectification and voltage regulation kept clear.
Practise Electronics
660 free Electronics MCQs from Physics, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Physics questions like this
Physics is on 16 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
More Rectification questions
The rectifier is a device that converts:
The maximum efficiency of a half-wave rectifier is:
Half wave rectifier passes only:
In a half wave rectifier, the diode conducts:
For non-inverting operational amplifiers, if R1 is infinite and R2 is 0 ohm, then the gainof amplifier is
A student gives input to a NAND gate as shown in the given diagram.