The frame of an induction motor is usually made of____________?
Correct answer: B. cast iron
- A. silicon steel
- B. cast iron
- C. aluminium
- D. bronze
Explanation
Cast iron is commonly used for induction-motor frames because it provides mechanical strength, rigidity and good protection. Aluminium is also used in lightweight small motors, but it is not the traditional usual answer.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
Practise Electrical Machines
1,061 free Electrical Machines MCQs from Electrical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Electrical Engineering questions like this
Electrical Engineering is on 2 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
More Electrical Machines questions
The shaft of an induction motor is made of_____________?
In an induction motor, no-load the slip is generally____________?
A 3-phase 440 V, 50 Hz induction motor has 4% slip. The frequency of rotor e.m.f. will be____________?
A series generator can self-excite:______________?
A D.C. generator works on the principle of____________?
The open circuit voltage of a compound generator is 250 V. At full load the terminal voltage____________?