The form factor is the ratio of_______?
Correct answer: B. r.m.s. value to average value
- A. peak value to r.m.s. value
- B. r.m.s. value to average value
- C. average value to r.m.s. value
- D. none of the above
Explanation
For an alternating waveform, form factor is defined as the ratio of its r.m.s. value to its average value, usually the rectified average. For a sine wave, this ratio is about 1.11.
Last updated
Practise Circuit Analysis
394 free Circuit Analysis MCQs from Electrical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Electrical Engineering questions like this
Electrical Engineering is on 2 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
Related questions
74. Sparking occurs when a load is switched off because the circuit has high_________?
A 12 kΩ resistor, a 15 kΩ resistor, and a 22 kΩ resistor are in series with two 10 kΩ resistors that are in parallel. The source voltage is 75 V. Current through the 15 kΩ resistor is approximately___________?
A 200 turn coil has an inductance of 12 mH. If the number of turns is increased to 400 turns, all other quantities (area, length etc.) remaining the same, the inductance will be___________?
A 3 Q resistor having 2 A current will dissipate the power of_______________?
A 40 W bulb is connected in series with a room heater. If now 40 W bulb is replaced by 100 W bulb, the heater output will__________