The driver stage usually employs_________________?
Correct answer: A. Class A power amplifier
- A. Class A power amplifier
- B. Push-pull amplifier
- C. Class C amplifier
- D. None of the above
Explanation
The driver stage normally uses a Class A amplifier because it provides good linearity and supplies the signal power needed to drive the final power stage. Push-pull operation is more commonly associated with the output stage.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
Practise Electronics and Devices
758 free Electronics and Devices MCQs from Electrical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Electrical Engineering questions like this
Electrical Engineering is on 2 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
More Electronics and Devices questions
What will be the collector efficiency of a power amplifier having zero signal power dissipation of 5 watts and a.c. power output of 2 watts ?
If the power rating of a transistor is 1W and collector current is 100mA, then maximum allowable collector voltage is________________?
If the gain versus frequency curve of a transistor amplifier is not flat, then there is distortion ?
The output signal voltage and current of a power amplifier are 5V and 200 mA; the values being r.m.s. What is the power output ?
The maximum a.c. power output from a class A power amplifier is 10 W. What should be the minimum power rating of the transistor used ?
The class B push-pull circuit can deliver 100 W of a.c. output power. What should be the minimum power rating of each transistor ?