Steady state one dimensional heat flow by conduction as given by Fourier's low does not assume that_______________?
Correct answer: C. Material is anisotropic
- A. There is no internal heat generation
- B. Boundary surfaces are isothermal
- C. Material is anisotropic
- D. Constant temperature gradient exists
Explanation
The usual one-dimensional Fourier-conduction model assumes an isotropic material, so thermal conductivity is not direction-dependent. Anisotropy requires a conductivity tensor and is therefore not part of the standard assumption set.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
Practise Heat Transfer Operations
645 free Heat Transfer Operations MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Heat Transfer Operations questions
The critical radius of insulation for a spherical shell is (where, K = thermal conductivity of insulating material h0 = heat transfer coefficient at the outer surface) ?
The most conducive surface for dropwise condensation to occur is the _____________ surface?
Shell side pressure drop in a shell and tube heat exchanger does not depend upon the_________________?
Heat transfer co-efficient (h1) for liquids increases with__________________?
In natural convection heat transfer, the correlating parameter is the_______________________?
Correction is applied to LMTD for __________ flow?