Response of a linear control system for a change in set point is called __________________?
Correct answer: C. Servo problem
- A. Frequency response
- B. Transient response
- C. Servo problem
- D. Regulator problem
Explanation
A control response caused by a change in set point is called a servo problem or servo response. A regulator problem instead concerns rejecting disturbances while the set point remains fixed.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Process Control and Instrumentation
254 free Process Control and Instrumentation MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Process Control and Instrumentation questions
Stroboscope is used for the measurement of _________________?
Nickel percentage in invar which is an iron-nickel alloy, and is used as a thermocouple material is __________________?
Conversion formula for converting amplitude ratio (AR) into decibels is ________________?
Which of the following is not a composition measuring instrument ?
Strain gage uses an electrical conductor wire, which when elastically stretched increases in length and reduces in diameter. Both these dimensional changes result in ____________ in the electrical resistance of the wire ?
Optical activity of a solution can be determined using a ___________________?