Plastic articles are normally produced by _____________ moulding?
Correct answer: B. Injection
- A. Green sand
- B. Injection
- C. Shell
- D. Dry sand
Explanation
Injection moulding melts plastic and forces it into a closed mould, making it suitable for producing large numbers of shaped plastic articles. Green sand, shell and dry sand are moulding materials or methods mainly associated with casting metals.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Chemical Process Principles
2,710 free Chemical Process Principles MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Chemical Process Principles questions
Temperature maintained in the emulsion polymerisation reactor for PVC manufacture is about ______________ ° C?
Diphenylamine is added to rubber to_________________?
Plastic tubes & pipes are generally made by ______________ moulding?
Low pressure Zeigler process for the manufacture of polythene uses a catalyst which is_______________________?
Polycaprolactam (Nylon - 6) is produced by the condensation polymerisation of caprolactam at 240-280°C in which the conversion of caprolactam is about ______________ percent?
Cellulose acetate has very high film permeability among all the polymers of the order of 5000 gm/100 m2. Which of the following polymers has the maximum film elongation (of the order of 100%) ?