Paramagnetism method is not used for the composition determination of ______________ in gases?
Correct answer: C. Carbon dioxide
- A. Oxygen
- B. Oxides of nitrogen
- C. Carbon dioxide
- D. Any of these
Explanation
Paramagnetic gas analysis is suitable for oxygen and nitrogen oxides because they exhibit paramagnetism. Carbon dioxide is diamagnetic, so it cannot be determined by this method.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Process Control and Instrumentation
254 free Process Control and Instrumentation MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Process Control and Instrumentation questions
Suppose that the gain, time constant and dead time of a process with the following transfer function: Gc(s) = 10 exp( - 0.1s)/(0.5s + 1) are known with a possible error of ± 20% of their values. The largest permissible gain Kc of a proportional controller needs to be calculated below taking the values of process gain, time constant and dead time as________________?
Transfer function of transportation lag is___________________?
An amplitude ratio of 0.1 corresponds to _____________ decibels?
The frequency response of a dynamic element shows a constant magnitude ratio at all frequencies. The element exhibits a negative phase shift at all frequencies. The absolute value of the phase shift increases linearly with frequency. The element has the transfer function ?
E.m.f. generated by thermocouples is of the order of ________________?
Liquid argon level in a pressurised storage tank (at 3 kg/cm2) is measured by a/an ____________________?