Often earing defects are found during deep drawing operation, because the __________________?
Correct answer: C. Starting sheet has planer anisotropy due to its texture
- A. Surface finish of the sheet is poor
- B. Sheet material has been given substantial spring back
- C. Starting sheet has planer anisotropy due to its texture
- D. Starting sheet has normal anisotropy due to its texture
Explanation
Earing is uneven cup height during deep drawing, caused by planar anisotropy in the sheet’s crystallographic texture. Normal anisotropy mainly affects drawability and wall thinning, not the formation of ears.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Plant Design and Economics
803 free Plant Design and Economics MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Plant Design and Economics questions
As per the Indian boiler regulation (IBR), the type of joint preferred for the circumferential joint is the _____________ joint ?
Depreciation of machines fails under the indirect expenses head. As per income tax regulations, it is calculated by the __________________ method?
____________________ metal is used as a bearing liner material?
_________________ is not a heat treatment process ?
______________ is not used as the control rod material in a nuclear reactor ?
Which of the following can be manufactured using powder metallurgy techniques ?