_______________ mill is normally used for grinding of talc?
Correct answer: C. Ring-roll
- A. Tube
- B. Compartment
- C. Ring-roll
- D. Pebble
Explanation
Ring-roll mills are commonly used for fine grinding of soft minerals such as talc. Their rolling and compression action is well suited to this relatively soft, non-abrasive material.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Chemical Process Principles
2,710 free Chemical Process Principles MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Chemical Process Principles questions
For achieving maximum capacity of the ball mill, the ball charge should be equal to about ______________ percent of the ball mill volume?
Half the angle of nip, (α), for a roll crusher is given by (where, dr, dp and df are diameters of crushing rolls, feed particles and rolls gap respectively) ?
Mixer used for rubber compounding is__________________?
Which of the following terminology is not used for size reduction of materials to fine sizes or powders ?
200 mesh screen means 200 openings per_____________________?
Screw conveyors are________________?