Log mean temperature difference in case of multi-pass shell and tube heat exchanger is always_________________?
Correct answer: A. Less than arithmetic mean value
- A. Less than arithmetic mean value
- B. More than arithmetic mean value
- C. More than geometric mean value
- D. Both B. & C.
Explanation
The logarithmic mean temperature difference lies between the geometric and arithmetic means, and the multipass correction factor further reduces the effective value. Thus it is less than the arithmetic mean, while option B states the opposite.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Heat Transfer Operations
645 free Heat Transfer Operations MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Heat Transfer Operations questions
In a shell and tube heat exchanger, the clearance of the tube is generally___________________?
In a double pipe (concentric) heat exchanger, the hydraulic radius for heat transfer (for a fluid flowing through the annulus) would be_________________?
Low pressure steam (with saturation temperature between 105 to 120°C) is usually used in the vacuum evaporators, which normally employ a vacuum of about _______________ mm Hg (referred to a 760 mm mercury barometer)?
Baffle spacing is generally _________________ the I.D. of the shell ?
In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube) ?
Heat transfer co-efficient for a horizontal condenser as compared to a vertical condenser operating under similar conditions is_______________?