In the design of a biasing circuit, the value of collector load RC is determined by__________________?
Correct answer: A. VCE consideration
- A. VCE consideration
- B. VBE consideration
- C. IB consideration
- D. None of the above
Explanation
R_C is selected from the desired collector voltage and operating-point condition, using the voltage drop V_RC = I_C R_C and the required V_CE. V_BE and I_B are used mainly to determine the base-bias network, not the collector load.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
Practise Electronics and Devices
758 free Electronics and Devices MCQs from Electrical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Electrical Engineering questions like this
Electrical Engineering is on 2 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
More Electronics and Devices questions
The stabilisation of operating point in potential divider method is provided by_______________?
When the temperature changes, the operating point is shifted due to _______________?
A silicon transistor is biased with base resistor method. If ß=100, VBE =0.7 V, zero signal collector current IC = 1 mA and VCC = 6V , what is the value of the base resistor RB ?
In a transistor amplifier circuit VCE = VCB +________________?
The stability factor of a collector feedback bias circuit is_______________ that of base resistor bias?
If the temperature increases, the value of VCE_________________?