In fluid flow, the boundary layer separation cannot occur___________________?
Correct answer: D. None of these
- A. In case of boundaries experiencing form drag
- B. At points of abrupt changes in the flow directions
- C. In laminar flow
- D. None of these
Explanation
Boundary-layer separation can occur in laminar flow when an adverse pressure gradient makes the wall shear stress fall to zero and then reverse. It is also associated with form drag and abrupt changes in flow direction, so none of the listed conditions excludes separation.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Fluid Flow Operations
909 free Fluid Flow Operations MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Fluid Flow Operations questions
Water hammer is caused, when water flowing in a pipe is suddenly brought to rest by closing the valve. The extent of pressure thus produced due to water hammer depends on the___________________?
A mono pump is a __________ pump ?
For pipes that must be broken at intervals for maintenance, the connector used should be a/an__________________?
Rotary vacuum pumps can reduce the absolute pressure to as low as __________ mm Hg ?
Bernoulli‟s equation does not apply to the functioning of a/an__________________?
Which of the fluid forces are not considered in the Reynold's equation of flow ?