Heat of solution for NaCl is ?
Correct answer: B. Low
- A. High
- B. Low
- C. Zero
- D. One
Explanation
The heat of the solution for NaCl is low. When NaCl dissolves in water then the enthalpy of the solution decreases and the reaction of NaCl with water is endothermic so, heat has to be added to the solution. Thus NaCl solution possesses low heat than normal water.The heat of the solution for NaCl is low. When NaCl dissolves in water then the enthalpy of the solution decreases and the reaction of NaCl with water is endothermic so, heat has to be added to the solution. Thus NaCl solution possesses low heat than normal water.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
About Chemical Equilibrium
Reversible reactions reach dynamic equilibrium when forward and reverse rates become equal, and Le Chatelier's principle predicts the effect of changing concentration, pressure or temperature. The chapter also covers solubility product, the common ion effect, buffer action and the conditions used in Haber's process, with equilibrium shifts distinguished from changes in the equilibrium constant.
Practise Chemical Equilibrium
625 free Chemical Equilibrium MCQs from Chemistry, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Chemistry questions like this
Chemistry is on 14 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
More Chemical Equilibrium questions
Volume factor can appear in equilibrium constant expression in:
The rate of reaction:
For higher yields of ammonia increase in temperature is replaced by which of the following?
As the reaction proceeds, the concentration of reactants _.
The formation of NH3 is a reversible and exothermic process, what will happen on cooling?
In the Contact Process for manufacturing sulphuric acid, Sulphur trioxide (SO3) is not absorbed in water because: