For the accurate measurement of electric current passing through a circuit, the resistance of the ammetre should be
Correct answer: A. lesser than the circuit resistance
- A. lesser than the circuit resistance
- B. greater than the circuit resistance.
- C. equal or lesser than the circuit resistance
- D. equal or greater than the circuit resistance
Explanation
The correct answer is Option A: lesser than the circuit resistance. This is because the ammeter should have a lower resistance than the circuit to avoid affecting the current flow and provide an accurate measurement. Options B, C, and D are incorrect as having the ammeter resistance greater, equal, or higher than the circuit resistance would introduce inaccuracies in the current measurement.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
About Steady Current
Steady current is the continuous flow of charge at a constant rate through a conductor. The topic covers current, charge, potential difference, resistance, Ohm's law, resistivity and electrical power, along with series and parallel circuits, while distinguishing conventional current direction from electron motion.
Practise Current Electricity
1,053 free Current Electricity MCQs from Physics, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Physics questions like this
Physics is on 16 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
More Steady Current questions
When the resistance remains constant, the graph of Ohm's law shows a/ an
The direction of conventional current flowing in an electric circuit is always from
According to Kirchhoff's first law, the CORRECT relationship between different currents passing in the given circuit diagram in terms of i2 is
The sensitivity of a galvanometre increases in relation to all of the following EXCEPT
If a voltage of 220 V is applied to a resistor of 20 Ω, then the amount of electric current in the circuit will be
In an electric kettle 250 ml water boils in 5 minutes. If the same amount of water needs to be boiled in half of the time by using the same power supply, which of the following conditionswould be applied?