For adhesion to be present between solid and liquid________________?
Correct answer: A. Liquid should wet solid surface
- A. Liquid should wet solid surface
- B. Mechanical interlocking should be present
- C. Should have high contact angle
- D. None of the above
Explanation
For a liquid adhesive to bond to a solid, it must wet and spread over the surface, which requires a low contact angle. A high contact angle indicates poor wetting, not effective adhesion.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Properties of Dental Materials
87 free Properties of Dental Materials MCQs from Dental Materials, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Dental Materials questions like this
Dental Materials is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Properties of Dental Materials questions
Brazilian test is used to determine the ultimates tensile strength of_________________?
Angles between Adhesive and Adherent is Zero degree, it indicates_______________?
The forces that hold atoms together are called_____________?
Munsell system is used to_________________?
The strain that occurs when a material is stressed to its proportional limit is______________?
Liquids which become more rigid as the rate of deformation increases is termed as_____________?