Combustion of furnace oil in a furnace (soaking pit) with preheated combustion air at 400°C results in saving of about __________ percent furnace oil as compared to its combustion with atmospheric air, if the flue gas outlet temperature from the soaking pit is 1200°C ?
Correct answer: C. 20
- A. 5
- B. 60
- C. 20
- D. 40
Explanation
Preheating combustion air to 400°C recovers a substantial part of the flue-gas sensible heat, reducing the furnace-oil requirement by approximately 20% under the stated high flue-gas temperature condition. The saving is therefore much greater than the 5% estimate but not as high as 40% or 60%.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Heat Transfer Operations
645 free Heat Transfer Operations MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Heat Transfer Operations questions
Regenerators are used for waste heat recovery in____________________?
Ceramic recuperators (made of SiC) is economical, only when used for preheating combustion air above _____________ °C?
Air filtration in a furnace___________________?
In a muffle furnace, the muffle_________________?
Hearth furnaces are not used for____________________?
Maximum heat transfer in high temperature furnaces is by____________________?