Bond crushing law_________________?
Correct answer: A. Calls for relatively less energy for the smaller product particles, than does the Rittinger law
- A. Calls for relatively less energy for the smaller product particles, than does the Rittinger law
- B. Is less realistic in estimating the power requirements of commercial crushers
- C. States that the work required to form particle of any size from very large feed is proportional
- D. to the square root of the volume to surface ratio of the product
- E. States that the work required for the crushing is proportional to the new surface created
Explanation
Compared with Rittinger's law, Bond's law predicts relatively less energy for producing very small particles because its energy requirement varies approximately with the inverse square root of particle size rather than the inverse particle size.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Chemical Process Principles
2,710 free Chemical Process Principles MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Chemical Process Principles questions
Filtration capacity of a rotary drum vacuum filter depends upon the_______________?
The specific cake resistance for incompressible sludges is (where ΔP = pressure drop over cake)__________________?
Which of the following is the most suitable filter for separation of abrasive solids suspended in a corrosive liquid ?
Sphericity for a non-spherical particle is given by (where, V and S are volume and surface area respectively of one particle. and, D = equivalent diameter of particle)?
A straight line is obtained on plotting reciprocal of filtration rate vs. the volume of filtrate for _______________ flow of filtrate?
Work index is the gross energy (kWh/tonne of feed) necessary to reduce a very large feed to such a size that 80% of product particles will pass through a 0.1 mm screen. The value of work index determined for wet grinding should be multiplied with ______________ to get the same for dry grinding?