A GTO can be turned on by applying___________?
Correct answer: A. Positive gate signal
- A. Positive gate signal
- B. Positive drain signal
- C. Positive source signal
- D. None of these
Explanation
A GTO turns on with a positive gate current or voltage relative to its cathode, just like an SCR. A negative gate signal is used to turn a GTO off.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
Practise Power Electronics
253 free Power Electronics MCQs from Electrical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Electrical Engineering questions like this
Electrical Engineering is on 2 papers prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for every one of them.
More Power Electronics questions
During which time maximum conduction spreading take place in the thyristor during turn ON?
Which of the following is true about SIT?
During reverse recovery time__________________?
The typical time of rising time lies between______________?
The reverse recovery time of diode is trr = 3 μs and the rate off all of the diode current is di/dt = 30 A/μs. The storage charge current QRR is___________?
Maximum power loss occurs during_________________?