A graph between _____________ is called Wilson plot?
Correct answer: A. (1/U) Vs. (1/v0.8)
- A. (1/U) Vs. (1/v0.8)
- B. (1/v0.8) Vs. U
- C. v0.8 Vs . U
- D. (1/U) Vs. (1/V)
Explanation
A Wilson plot linearizes the overall-resistance relation by plotting 1/U against the inverse velocity term, commonly 1/v^0.8. The intercept represents other resistances while the slope helps determine the relevant film coefficient contribution.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? support@testustad.com
Practise Heat Transfer Operations
645 free Heat Transfer Operations MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Heat Transfer Operations questions
Fouling factor for a heat exchanger is given by (where, U1 = heat transfer co-efficient of dirty surface U2 = heat transfer co-efficient of clean surface) ?
All analogy equations connecting friction factor and heat transfer co-efficient apply only to ___________________?
Reason for operating an evaporator in multiple effects is to secure ___________________?
Walls of a cubical oven are of thickness l, and they are made of material of thermal conductivity k. The temperature inside the oven is 100°C and the inside heat transfer coefficient is „3k/l'. If the wall temperature on the outside is held at 25°C, what is the inside wall temperature in degree centigrade ?
For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it__________________?
Tube height in a calandria type evaporator is normally less than _______________ metres?