25 per cent cut segmental baffle means that the baffle__________________?
Correct answer: B. Height is 75% of the I.D. of the shell
- A. Height is 25% of the I.D. of the shell
- B. Height is 75% of the I.D. of the shell
- C. Spacing is 75% of its height
- D. Width is 25% of its height
Explanation
A 25 percent segmental baffle cut means that 25 percent of the shell diameter is removed from the baffle. The remaining baffle height is therefore 75 percent of the shell inside diameter.
Report an error
The more specific you are, the faster it gets fixed. A source beats an opinion.
Prefer email? [email protected]
Practise Heat Transfer Operations
645 free Heat Transfer Operations MCQs from Chemical Engineering, each with the correct answer and an explanation. Unlimited attempts, no account needed.
Discussion
Stuck on an option, or know a faster way to get there? Ask or explain it here.
No comments yet. Be the first to explain this one.
Exams that ask Chemical Engineering questions like this
Chemical Engineering is on this paper prepared for on TestUstad, and all of them draw the same bank, so this question is worth knowing for it.
More Heat Transfer Operations questions
In a multipass shell and tube heat exchanger, the shell side cross flow area does not depend upon______________________?
Tube side pressure drop in a 1-2 heat exchanger (for turbulent flow of fluids through the tubes) is about __________ times, that in a 1-1 heat exchanger having the same size & number of tubes and operated at the same liquid flow rate ?
It is not desirable to design a heat exchanger for LMTD correction factor, FT, of less than _________________?
In a shell and tube heat exchanger, the 'tube pitch' is defined as the _____________________?
Shell side heat transfer co-efficient in case of square pitch as compared to the triangular pitch under similar condition of fluid flow and tube size is_____________?
Which of the following lengths of heat exchanger tubes are normally not used in practice ?